Is it possible to make connections using Wi-Fi AP Mode and a wired LAN adapter (sold separately) at the same time?

IMPORTANT: This article applies only to specific products and/or operating systems. Check the Applicable Products and Categories section of this article before starting these steps.

Simultaneous connection is possible.

When a wired LAN adaptor (sold separately) is used to establish a connection with a router or other device while a smartphone is connected via Wi-Fi to the ILME-FX6 operating in Wi-Fi AP Mode, the following message may be displayed:

The IP address of the Wireless LAN Access Point Mode has been changed due to an IP address conflict.

If this message appears, communication between the smartphone connected via Wi-Fi AP Mode and the ILME-FX6 may have been disconnected.
If a message indicating that you have been disconnected is displayed on the Content Browser Mobile application screen or the remote control monitoring function does not operate properly, reestablish the Wi-Fi connection with the ILME-FX6, such as by turning the Wi-Fi function Off then On again on the smartphone.